LDAP Integration

RE: LDAP Integration

aswinb608 — Thu, 28 Dec 2017 17:16:20 GMT

Some people use preAuth header for doing SSO such as when they have Oracle OID. How would you do that on admin console? I was only telling to use spring security override in such cases.

RE: LDAP Integration

Mike Cichy — Thu, 28 Dec 2017 16:05:55 GMT

That is not a good recommendation. Use of Spring security config files is no longer supported. Sure, if you do it, it *may* work but the OP will be on their own to troubleshoot. There is documentation on how to migrate the configuration to the admin console and that is what is recommended.

RE: LDAP Integration

aswinb608 — Thu, 28 Dec 2017 15:42:47 GMT

ldap configs from 7.6 to 7.11 used to be in spring security files. In 16.x versions, you can do it in two ways: admin console and spring security files again. Easiest way is to do it in admin console under ldap section. If you have SSO going on with spring security override files then i recommend keeping it that way.

RE: LDAP Integration

Mike Cichy — Wed, 11 Oct 2017 19:21:36 GMT

Here is the migration guide: community.appian.com/.../migrating-ldap-configuration-to-administration-console

As a side note, I think you also have to upgrade to 16.2 as an intermediate step and then to 17.3.

RE: LDAP Integration

mohammedi — Mon, 09 Oct 2017 06:37:51 GMT

Hi,

In the earlier version the LDAP authentication was stored at the server config files, from 16 on wards you can use the front end to configure the same. You need extract the details from the file "spring-security-03-auth-mgr-override.xml"(from your backup installation) and go to the admin tab and replicate the same.

RE: LDAP Integration

Colton Beck — Fri, 06 Oct 2017 20:26:57 GMT

Was LDAP configured by Appian Support while you were still on 7.6? If so, I recommend reaching out to them to assist in migrating the configurations.