I am trying to setup a receive message action in a process model, but while tryi

RE: I am trying to setup a receive message action in a process model, but while tryi

Patty Isecke — Thu, 16 Jan 2014 20:19:21 GMT

Would you be able to provide a screencast? You can use http://screencast.com/ to do so.

RE: I am trying to setup a receive message action in a process model, but while tryi

padmanabhanv — Thu, 16 Jan 2014 20:16:01 GMT

Yes that is done

RE: I am trying to setup a receive message action in a process model, but while tryi

Patty Isecke — Thu, 16 Jan 2014 19:42:24 GMT

Please confirm these are the steps taken: User Input Task > Escalations tab > Send Message Event > Message Destination defined as your receive process model.

RE: I am trying to setup a receive message action in a process model, but while tryi

padmanabhanv — Thu, 16 Jan 2014 19:24:29 GMT

@patty, Yes, I need to escalate a task and when the escalation condition is met send a message to another process. But when I configure this send event, it is not visible when i try to import custom properties in the receive message event in the other process.

RE: I am trying to setup a receive message action in a process model, but while tryi

Patty Isecke — Thu, 16 Jan 2014 17:39:30 GMT

You can send messages from an end event: forum.appian.com/.../Send_Message_Event

It looks like to send a message as an escalation, you'll be escalating a task: forum.appian.com/.../Escalating_a_Task

RE: I am trying to setup a receive message action in a process model, but while tryi

padmanabhanv — Thu, 16 Jan 2014 03:38:46 GMT

Yes Patty, I had verified that

RE: I am trying to setup a receive message action in a process model, but while tryi

Patty Isecke — Thu, 16 Jan 2014 03:37:28 GMT

Have you configured the start node to have a receive message as a trigger? Did you save and publish the process model that is does the send message?

RE: I am trying to setup a receive message action in a process model, but while tryi

padmanabhanv — Thu, 16 Jan 2014 03:03:22 GMT

UPDATE - The event in the parent process is showing up if I add the send message in an "END" node. However the send message event that I have configured as part of an escalation in the same process does not show up. The escalation that sends the Send Message event is at Level 3, could the ordering be an issue there?