Use a! startProcess from an interface

RE: Use a! startProcess from an interface

marco.basolu — Tue, 16 Apr 2024 15:32:24 GMT

I everybody! I have the same problem, but I can't find the solution like yours.

I want to show a message in case of success/error from a processModel, but if I put the a!save into the onSuccess/onError, it returns me immediately the onSuccess message.

Consider that the integration gives me error after 10 seconds.

RE: Use a! startProcess from an interface

nupoorn0002 — Wed, 27 Nov 2019 13:31:59 GMT

we did activity chaining and also selected the option in Sub-process with check box to add chaining.

RE: Use a! startProcess from an interface

nupoorn0002 — Wed, 27 Nov 2019 13:30:57 GMT

We have used the same thing in our UI, but we are receiving the response some times but sometimes no response. Any help is appreciated.

Thanks,

Nupoor

RE: Use a! startProcess from an interface

Krishna Chaitanya Mallavarapu — Fri, 22 Nov 2019 10:59:34 GMT

make sure that you have done activity-chaining to all nodes in your process model

RE: Use a! startProcess from an interface

Soujanya B — Fri, 22 Nov 2019 10:39:29 GMT

Hi ,

I have the same issue , I could not see the fv!process.pv values in Interface once the process model execution is done on Sucess parameter.

Any help is appreciated.

RE: Use a! startProcess from an interface

sandrap845 — Mon, 30 Sep 2019 16:44:45 GMT

This was the solution thank you very much!

RE: Use a! startProcess from an interface

Mike Schmitt — Mon, 30 Sep 2019 15:15:40 GMT

[quote userid="28432" url="~/discussions/f/integrations/17689/use-a-startprocess-from-an-interface/69641"]but I need to save the result of the startProcess in some variable[/quote]

Yes, and for this you would use the onSuccess parameter of the link and add a save that captures the data you want into your local values.

RE: Use a! startProcess from an interface

sandrap845 — Mon, 30 Sep 2019 15:13:32 GMT

Hi Mike,
but I need to save the result of the startProcess in some variable and then use it to paint the table.

Regards, and thank you very much

RE: Use a! startProcess from an interface

Mike Schmitt — Mon, 30 Sep 2019 15:08:13 GMT

In your current configuration, you seem to be saving your a!startProcess() call into a local variable. As far as I know this is incorrect (and probably the cause of your issue) - your a!startProcess() call should stand alone within the saveInto, more like this:

saveInto: {
  a!startProcess(
    processModel: cons!PROCESO_PRUEBA,
    processParameters: {
      entrada: ri!entrada
    },
    ...
  )
}