In Process model & interface

RE: In Process model & interface

ajhick — Mon, 07 Mar 2022 08:27:44 GMT

As Stefan has already said, this isn't how the test values work. You CAN have defaults, just not through the test interface section.

In the process model you could do default values a few ways and one way is in the Process Start Form tab of the Start node. As can be seen below there are two values and I've utilised a!defaultValue() to set the values if no input was received.

When I run the process model for debugging the default values show.

RE: In Process model & interface

GopalK — Mon, 07 Mar 2022 07:05:20 GMT

Hi, you can keep default values in local variables or you can configure your process variables with some default value and when price will start ,you will see those values.

RE: In Process model & interface

Stefan Helzle — Sat, 05 Mar 2022 11:19:43 GMT

This is not how it works. Test values are, well, test values.

RE: In Process model & interface

reshman0003 — Sat, 05 Mar 2022 11:15:05 GMT

I want to make the test values used in the interface as the default values in the process model. for the start form.

RE: In Process model & interface

Stefan Helzle — Sat, 05 Mar 2022 11:07:53 GMT

That is described in the link I shared above.

If this does not fit your goals, please describe what you want to achieve.

RE: In Process model & interface

reshman0003 — Sat, 05 Mar 2022 11:02:45 GMT

How to assign the values in the process variables

RE: In Process model & interface

Stefan Helzle — Sat, 05 Mar 2022 10:54:22 GMT

The values passed in the interface designer are for testing purposes only.

To feed default values into a start form, you need to assign values to the process variables in the model.

RE: In Process model & interface

reshman0003 — Sat, 05 Mar 2022 04:11:49 GMT

I tried both link suggested above I didn't get how to proceed

I have made use of default values in the interface during test but when I run process model there are no values(as shown in 3rd image).

Could you please suggest

RE: In Process model & interface

ajhick — Sat, 05 Mar 2022 02:06:56 GMT

What Stefan said and you could also use a!defaultValue() too.

https://docs.appian.com/suite/help/22.1/fnc_informational_a_defaultvalue.html

Depending on your use case this could be either on the Process Start Form tab of the start node or in the interface. AFAIK you can't use process variables in the Variables tab of the process model.

a!defaultValue(
  value: pv!car.make,
  default: "Ford"
)

a!defaultValue(
  value: pv!car.make,
  default: "No make input recieved"
)

RE: In Process model & interface

Stefan Helzle — Fri, 04 Mar 2022 18:59:51 GMT

Please try this

docs.appian.com/.../recipe-set-the-default-value-of-an-input-on-a-start-form.html