Send and Receive Message - DestinationProcessId

RE: Send and Receive Message - DestinationProcessId

jurim409 — Thu, 21 Dec 2017 15:18:20 GMT

Hi,
thanks to everybody for any suggestion.
It was my mistake to set both the message destination and the DestinationProcessId.
So, I left empty the message destionation and it works now.

RE: Send and Receive Message - DestinationProcessId

Sowrabha Rajashekar — Thu, 21 Dec 2017 03:37:40 GMT

True ! I agree

RE: Send and Receive Message - DestinationProcessId

Ashvin Kapur — Wed, 20 Dec 2017 13:58:39 GMT

Afaik, you can have an array for your variable and don't need to run MNI on the send message - you can do it all at once, which would be less expensive.

RE: Send and Receive Message - DestinationProcessId

ganeshbabuj — Wed, 20 Dec 2017 12:33:18 GMT

Check below instances
1. How have u got the process Id of Designation PM? Check if you have seperate pv! for all required Designation PM for those u need to send message to.
2. Setup Tab : JMS Message Destination* : Process
3. Setup Tab : Message Type* : Process to Process
4. Setup Tab : Message Destination(s) : NEEDS TO BE LEFT BLANK
5. Have 1 "Send Message" for 1 Designation PM to receive message. In your case u might need as many for each Designation PM.

After you receive the message appropriately, u will come up with one other problem that PM will be on active/running status, if it does not get a message as the "Receive Message" node will keep on waiting.

To fix this issue
1. Have the output of "Receive Message" as 1 input to Complex Gate and 2 input from the node before "End Event".
2. On Complex Gate set 1 incoming paths and for Outgoing paths "Execute all outgoing paths at the same time".
3. If you design supports Instead of End Event make it Terminate.

RE: Send and Receive Message - DestinationProcessId

Sowrabha Rajashekar — Wed, 20 Dec 2017 08:53:44 GMT

[deleted]

RE: Send and Receive Message - DestinationProcessId

shwetap — Wed, 20 Dec 2017 08:53:09 GMT

Hi Jurim
I tried this with multiple process instances of receiver process model.Its running fine for me i just used tointeger(process instance id) in the destination process id field in "DATA tab" and made message destination(s) field in "SETUP" tab as blank .
Thanks,
Shweta p.

RE: Send and Receive Message - DestinationProcessId

jurim409 — Wed, 20 Dec 2017 07:02:15 GMT

Hi,
I mean the receiver of a process model. If I use a Send Message with a given Process Id, then Appian ignores this process Id and sends the message to all active processes.
Thanks,
Juri

RE: Send and Receive Message - DestinationProcessId

Ashvin Kapur — Tue, 19 Dec 2017 23:07:07 GMT

Hi Juri,

I'm not sure I fully understand your question. If you have one Send Message event, it sends to the correct destination process instance, but if you have multiple, all Receive Message Events are being triggered? What do you mean by "all receiver processes"? In your entire platform? application? process model type?

For more information around the events, use the following links:
docs.appian.com/.../Send_Message_Event.html
docs.appian.com/.../Receive_Message_Event.html

-Ashvin