Process Instance run 785 times in single run

RE: Process Instance run 785 times in single run

Malleswari Talakola — Fri, 07 Jun 2019 14:53:44 GMT

Yes steven,you are right.Arrows are aligned improperly and moving back and forth.fixed it.Thank you so much for the help.

RE: Process Instance run 785 times in single run

davel001150 — Fri, 07 Jun 2019 13:28:12 GMT

I see the same thing you're seeing, Steven, and all sorts of other strange paths the connections are taking. Whenever you have multiple outputs of a process node, they all run. When multiple inputs go into a script task, the script task is run once for each time process flow reaches it.

So it looks like you are going back to the first script task and starting the whole thing over again repeatedly until you finally terminate the process.

As others have suggested you should delete all connections between these nodes and rebuild them from scratch. Leave the nodes where they are and reconnect them.

RE: Process Instance run 785 times in single run

Apoorv Gangwar — Fri, 07 Jun 2019 00:52:49 GMT

Please check the connectivity between the green colored nodes.

RE: Process Instance run 785 times in single run

Steven Miccile — Thu, 06 Jun 2019 21:35:38 GMT

Looking very closely at this picture, I think you have arrows going in both directions between "Requires S24 Review" and "Determine if Failed" (though it is very hard to tell / confirm). It could be bouncing infinitely back and forth...

RE: Process Instance run 785 times in single run

davel001150 — Thu, 06 Jun 2019 20:19:44 GMT

How many times did Routing Decision run? When seeing similar to this in my own project, it was an issue with subprocess not terminating the way one would expect, causing multiple outflows. Meaning, it's likely you somehow have 785 instances of the line between Routing Decision and Case Status, or 785 outputs of Case Status.

RE: Process Instance run 785 times in single run

Malleswari Talakola — Thu, 06 Jun 2019 17:43:04 GMT

sure,

RE: Process Instance run 785 times in single run

Malleswari Talakola — Thu, 06 Jun 2019 17:40:46 GMT

Thanks for the reply,it is not configured to be M NI, no Looping, no one started it manuallly.Nothing set up for MNi nodes.This is happening suddenly.

RE: Process Instance run 785 times in single run

Steven Miccile — Thu, 06 Jun 2019 17:08:59 GMT

Specifically looking for an MNI setup that moves on "each time an instance completes"

RE: Process Instance run 785 times in single run

Robert Shankin — Thu, 06 Jun 2019 16:39:57 GMT

Can we see the rest of the model?

What's obscured by the spawned nodes window?