Cant load interfaces from a process model from another

RE: Cant load interfaces from a process model from another

Mike Schmitt — Wed, 24 Nov 2021 14:11:55 GMT

First you need to add a user input task, since you don't have any in your subprocess.

RE: Cant load interfaces from a process model from another

Frad3l — Wed, 24 Nov 2021 13:08:12 GMT

How should i configure the user input task?

RE: Cant load interfaces from a process model from another

Tanvir Sarkar — Wed, 24 Nov 2021 12:46:45 GMT

Frad3l use user input task after start node inside sub process, also use activity chaining while doing that

RE: Cant load interfaces from a process model from another

Frad3l — Wed, 24 Nov 2021 12:20:02 GMT

ok, now it goes to the process model I wanted, but does not load the interface

RE: Cant load interfaces from a process model from another

Stewart Burchell — Wed, 24 Nov 2021 11:56:22 GMT

You're using the "Start Process Model" n ode which starts a process model asynchronously and which, by definition, will not take your user synchronously to the user interface in your target process model. You'll need to call your process models as sub-processes ensuring that both parent and child processes are chained so as to provision the synchronous experience.

RE: Cant load interfaces from a process model from another

Stefan Helzle — Wed, 24 Nov 2021 11:54:16 GMT

To make that work, you would need to use the sub-process node instead of Start Process. And make the start form of the second process a normal user input task as a sub-process node does not show that to the user.

RE: Cant load interfaces from a process model from another

Frad3l — Wed, 24 Nov 2021 11:32:40 GMT

This is the landing page, after user clicks "GO IN", it should pass the user type to the xor and loads the nesxt process model