Multiple Values in PV

Question

The variable sequenceNumberTwo has multiple values and I am looking for each value to be sent to GET Transit Image Front and GET Transit Image Back. 
 Can you help me achieve this?

cindyl5142 · Accepted Answer

Here are my latest results after doing your suggestions... :( I appreciate your help btw.. 
 For some reason, sequenceNumberTwo is now 6 values, when it should only be 702 and 703. Also, unfortunately, it is only storing transitImageBack for 702 and transitImageFront for 703 I am looking to have transitImageBack for 702 and 703 and transitImageFront for 702 and 703

osanchea · Answer

Here I see a few things that seem to be misconfigured: 
 1. In the MNI configuration, select the option * Run all instances are done > "All instances are done" 
 2. It's not necessary to save the same value from each instance into the same variable sequenceNumberTwo, because this will cause 2 additional values to be added to the list you had defined at the beginning. 
 3. In the output configuration of the "Get Transit Image Front" node, it's set to save the body of the integration only once. To save the result.body from each instance, you should configure it like this: 
 Note: You should apply this same configuration to each node configured with MNI.

Shubham Aware · Answer

Remove the xor and connect both get Transit Image nodes in parallel from the previous node. Change the output operator from is appended to list to is stored as and use separate target variables instead of appending back to sequenceNumberTwo. This will process both sequence numbers through both nodes simultaneously.

Multiple Values in PV

Top Replies