Hi, Could anyone let me know the reason for the following error after installati

sikhivahans over 11 years ago

Hi, Could anyone let me know the reason for the following error after installation? Here is the message that has been logged,

JBAS014613: Operation ("add") failed - address: ([
("subsystem" => "messaging"),
("hornetq-server" => "default"),
("broadcast-group" => "appian-broadcast-group")
]) - failure description: "JBAS011679: The broadcast group 'appian-broadcast-group' defines reference to nonexistent connector 'netty'. Available connectors '[]'."

TIA,...

Discussion posts and replies are publicly visible

0 Sathya Srinivasan
Appian Employee
over 11 years ago

What version are you trying to install? Seems like you have configuration mistakes in your message queue definition.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Sathya Srinivasan
Appian Employee
over 11 years ago

If you're using Appian 7.3, try using Appian Configuration Manager to build your initial environment (Available under Software section). If its prior, try using psBuild (for the appropriate version) downloadable from Shared Components
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Eduardo Fuentes
Appian Employee
over 11 years ago

As Sathya suggests this error indicates a misconfiguration of your standalone.xml. In case you decide not to use the Appian Configuration Manager and prefer to troubleshoot this, you have to review your standalone.xml and follow each of the steps from forum.appian.com/.../Configuring_JBoss again to identify the root cause.

Based on the error you should focus on the "Configure JMS" section of that link where you are instructed on adding the connector which you are missing (based on the error message)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sikhivahans over 11 years ago

@sathya & Eduardo..Thanks for the suggestions, will recheck standalone.xml and get back.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel