Start Process for Debugging not displaying form

Question

Hi 
 On my process modeller, whenever I debug the process model, the Process Start Form does not display, the process continues to the next steps without the option to populate the form.

Is there a setting for enabling and disabling the Process start form or is this just in my environment? 
 Thanks in advance

shanem0001 · Accepted Answer

"This was posted by Someone two years ago and its the same issue" 
 I had a similar problem. My browser language was set to "English (GB)". 
 
 From "Appian Process Modeler"

Select "Properties".

Select "Process Start Form".

Choose the "English (GB)" tab.

Select the "Enable this language" check box.

Select the interface and select "Yes" to the "Create Process Parameters" prompt.

Select "File...Save and Publish".

Select "File...Start Process for Debugging".

This works if I blocked pop-ups or not, so that may be a red herring. 
 
 I hope this helps. 
 
 Regards, 
 
 Jules

Start Process for Debugging not displaying form

Top Replies