Appian Community
Site
Search
Sign In/Register
Site
Search
User
DISCUSS
LEARN
SUCCESS
SUPPORT
Documentation
AppMarket
More
Cancel
I'm looking for ...
State
Not Answered
Replies
12 replies
Subscribers
7 subscribers
Views
3952 views
Users
0 members are here
Share
More
Cancel
Related Discussions
Home
»
Discussions
»
General
Hi All, I am facing a very strange problem, where I am using a Execute Process r
harshav
over 8 years ago
Hi All, I am facing a very strange problem, where I am using a Execute Process report, and I am having a column of ID, which is the same variable in all the sub processes and the mail processes as well. Now in Dev, this is having all the IDs, and after moving to Prod the value of this is not getting populated, due to which I am not able to apply a condition with COlumn ID= ID value, and My process is failing, I went into that instance and I can see the data is available in the PV. pv!CDT.ID is the pv name.
Can anybody tell me how to figure out this problem
Thanks In advance!!!
OriginalPostID-213114
OriginalPostID-213114
Discussion posts and replies are publicly visible
Parents
0
sikhivahans
over 8 years ago
@harshav May I please ask you to observe any differences between the processes that are able to populate value and that aren't? I believe it would be tough to conclude until and unless we draw a pattern by carefully analysing the artifacts(that is, for instance, is the PV multiple in some cases and singular in other cases?).
One more question please - Would you please be able to configure the value as pv!CDT.id[1] or pv!CDT[1].id and check once again?
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
Reply
0
sikhivahans
over 8 years ago
@harshav May I please ask you to observe any differences between the processes that are able to populate value and that aren't? I believe it would be tough to conclude until and unless we draw a pattern by carefully analysing the artifacts(that is, for instance, is the PV multiple in some cases and singular in other cases?).
One more question please - Would you please be able to configure the value as pv!CDT.id[1] or pv!CDT[1].id and check once again?
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
Children
No Data