Hi All, i have created a process model(parameters are num1, num2) and

Venu over 9 years ago

Hi All,

i have created a process model(parameters are num1, num2) and published it as Web service.
i used the WSDL in call web service node to thest the web service.
i select the operation name "start" (this is only availbe, created by appian), then in inputs tab one ACP startRequest of start type is created.
This ACP doesn't contains the fields what i required (num1, num2). it refres to start cdt which is created earlier for different web service.

Any suggestions.

Discussion posts and replies are publicly visible

0 shivakanthr over 9 years ago

As per my knowledge the fields created in peocess model (Published as webservice) wont be available in inputs tab of call web service node.
If it is your requirement, then
Instead of calling WSDL in call web service node, you can implement it via Sub process...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 shivakanthr over 9 years ago

find below post. it might be helpful for you

forum.appian.com/.../e-158097
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Venu over 9 years ago

@shivakanth
i need to call this process model form out side.
for testing i used call web service.
once wsdl is configured, input cdt will be created created as attached.
in my case instead of creating it uses existing cdt created for another web service earlier.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 shivakanthr over 9 years ago

Can you try with SAOP UI
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Venu over 9 years ago

Is it possible to send document to Appian WSDL.

in my web service process model one parameter is document type.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 shivakanthr over 9 years ago

No
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel