Process is not starting on timer / schedule

Question

I have a process model with a timer set on the start node to trigger every 2 minutes. After deploying the application to a different environment the process never started. I tried republishing but it didn't anyway. No records in /designer, no alerts or warnings.

niteshtiwari · Accepted Answer

It might be due to the schedule delay setup..Is it worth putting your timer setup screen shot here??Also, for recurring schedule min allowed time in 5 min so was eager to see how you have configured your timer.

Arun Manoj Senthil Kumar · Answer

Hi Mr.osuvorov, 
 
Good Day!!! 
 
Go to Timer -> Setup in Start Node and Click "Show Advanced Options" to check whether any timer conditions/expressions defined which may be a reason for blocking the trigger. 
 
Hope this helps! 
 
Thanks, 
 
Arun Manoj S

mohamedt808 · Answer

Hi , 
 
Recurrence interval cannot be set less than 5 minutes. The same applies while using a constant as well. Also each time you change a constant that doesn't reflect automatically you will have to publish the process model to take the new value for recurrence. 
 
Regards, 
Mohamed Thoufiq.

osuvorov · Answer

Ok, so that's probably the case, because I have it defined as a constant. I will check and update this topic. Thanks, nitesht!

hedn89 · Answer

Hi Osuvorov, 
 As mentioned by other members, we get the below warning when we manually enter less than 5 mins for the timer.

Process is not starting on timer / schedule

Top Replies