Problems resulting from changes to CDT... For a process, had a table

seemag over 12 years ago

Problems resulting from changes to CDT...

For a process, had a table with 3 fields. Added a new field - changed and published CDT, republished datastore, ran impact analysis, remapped fields in process designer. But, now only the new field is being written to, the original three fields stay null.

Has anyone else observed this behaviour? Any suggestions other than deleting and recreating CDT?...

Discussion posts and replies are publicly visible

Parents

0 Sathya Srinivasan
Appian Employee
over 12 years ago

Can you check if the database has the same schema as the CDT? Also, check if the mapping in the Write to CDT is done at a CDT level and lastly, check if the CDT is populated with the correct data in all its fields.
Worth checking if there are any logs in Appserver. I dont expect any but always good to check this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Sathya Srinivasan
Appian Employee
over 12 years ago

Can you check if the database has the same schema as the CDT? Also, check if the mapping in the Write to CDT is done at a CDT level and lastly, check if the CDT is populated with the correct data in all its fields.
Worth checking if there are any logs in Appserver. I dont expect any but always good to check this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data