I am using a complex gate in a process, when i connect the in-flows and the out-

Mohammad Abusinnah

Appian Employee

over 13 years ago

I am using a complex gate in a process, when i connect the in-flows and the out-flows into the gateway and decide to delete one of the inflows then the modeler does not allow me?

Anybody is facing this?

Discussion posts and replies are publicly visible

Parents

0 natasav over 13 years ago

Yup, delete the whole gateway and reconfigure new gateway again .I don't know why this is happening but this work-around is working.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 natasav over 13 years ago

Yup, delete the whole gateway and reconfigure new gateway again .I don't know why this is happening but this work-around is working.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data