Hi everyone... i have the following question: when i initiate a process model on

fredericom over 9 years ago

Hi everyone... i have the following question: when i initiate a process model on "designer" everything works fine, but when i access on "apps" i get the following error "Invalid Process Model". Any suggestions about this behabior?

Thanks

Discussion posts and replies are publicly visible

0 silambarasanr
A Score Level 1
over 9 years ago

Hi fredericom,

Kindly follow the below steps,
1.Check whether the process model was published properly. Check its sub-processes were published.
2.Check for versions, make sure the current version of all models is not disabled.

Hope this helps!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel