While working in the Appian Process Modeler (Designer Mode) I can't seem to

stephenc897 over 9 years ago

While working in the Appian Process Modeler (Designer Mode) I can't seem to move the Angular Connector to a position I want. Any idea how I can control it's position? I think I've tried most of the obvious options but without success. I'd appreciate any feedback on this.
Thanks,
Stephen

Discussion posts and replies are publicly visible

Parents

0 stephenc897 over 9 years ago

Under 'normal' settings how would you adjust the connector to the position you want? click on the right angle and pull as per any other BPM systems? And which technology does the Process Modeler use/is written in? e.g. JavaScript, html5? etc...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 stephenc897 over 9 years ago

Under 'normal' settings how would you adjust the connector to the position you want? click on the right angle and pull as per any other BPM systems? And which technology does the Process Modeler use/is written in? e.g. JavaScript, html5? etc...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data