201380 - no subject - Hi, I have Process and Tasks reports cre

madhubindug over 8 years ago

Hi, I have Process and Tasks reports created. In Process if I choose the select sub-process data option, CDT variables are not populated, if I don't choose that option, values exists. Also in the tasks reports though the process variables are available but CDT data is blank. Could someone suggest any to retrieve CDT values in the process report and tasks report

Thanks,
Madhu

Discussion posts and replies are publicly visible

0 anshuk611 over 8 years ago

Have you mapped the output variables in the subProcess node setup tab in the main process?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 madhubindug over 8 years ago

Yes
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 shivakanthr over 8 years ago

Can you check the cdt name is same in both the process models?
sometimes report wont show data if the name is different in both PMs
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel