In the Appian Installation Documentation, it says that "Distributed install

jordanp over 11 years ago

In the Appian Installation Documentation, it says that "Distributed installations require static IP addresses for each server." Does it truly have to be static? Or is it good enough if it is assigned by DHCP and then reserved so that it doesn't change after that? Or does it truly have to be set up as a "static" IP address?...

Discussion posts and replies are publicly visible

Parents

0 Sathya Srinivasan
Appian Employee
over 11 years ago

Jordan, the static IP address / FQDN are used to communicate between the servers. I have used static IP in the past (as per documentation). I am pretty sure FQDN would work but I would strongly recommend following what the document says. FQDN also requires DNS lookup which may cause latency (albeit very small) - So IP address is the best bet.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Sathya Srinivasan
Appian Employee
over 11 years ago

Jordan, the static IP address / FQDN are used to communicate between the servers. I have used static IP in the past (as per documentation). I am pretty sure FQDN would work but I would strongly recommend following what the document says. FQDN also requires DNS lookup which may cause latency (albeit very small) - So IP address is the best bet.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data