Appian Community
Site
Search
Sign In/Register
Site
Search
User
DISCUSS
LEARN
SUCCESS
SUPPORT
Documentation
AppMarket
More
Cancel
I'm looking for ...
State
Not Answered
Replies
6 replies
Subscribers
10 subscribers
Views
5182 views
Users
0 members are here
Share
More
Cancel
Related Discussions
Home
»
Discussions
»
Administration
I note that when autocheckpointing in turned on, checkpoints will be run W
timh
over 12 years ago
I note that when autocheckpointing in turned on, checkpoints will be run
Where can I find out more information about configuring checkpointing?
What is the average time it takes for a checkpoint to run for example? The documentation says that if autocheckpoint is enabled, then a checkpoint will run "approximately once every 4 to 12 hours, depending on a number of factors, including transaction volume”.
Where can I find information on what those factors are, or what the transaction volume thresholds are that would trigger a 4, 5 or 12 hourly checkpoint? Is there a "Checkpoint Best Practices" page for example?...
OriginalPostID-33543
OriginalPostID-33543
Discussion posts and replies are publicly visible
Parents
0
Mike Cichy
Appian Employee
over 12 years ago
1) You can easily tell by the kdb last modified timestamp. Like I said, these times will vary on a number of factors.
2) You will need to inspect the db logs, and calculate the time between initiation of the save to the kdb switch. Normally the save is limited by I/O because of writing the sizeable files to disk but should take less than a few seconds on DEV. You can open an Appian Support case to help you identify the start and end times.
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
0
joanneh
over 6 years ago
in reply to
Mike Cichy
Hi
Mike Cichy
Do you know how to disable auto checkpointing?
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
0
nathan.schmitz
Certified Associate Developer
over 6 years ago
in reply to
joanneh
In the server/_conf directory update the gateway-config.xml file to set the auto-database-save="0" to disable auto check pointing.
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
0
Eliot Gerson
Appian Employee
over 6 years ago
in reply to
joanneh
The documentation here
docs.appian.com/.../Configuring_Application_Checkpointing.html
includes the current (since 17.3) guidance for checkpointing and instructions for configuring it.
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
Reply
0
Eliot Gerson
Appian Employee
over 6 years ago
in reply to
joanneh
The documentation here
docs.appian.com/.../Configuring_Application_Checkpointing.html
includes the current (since 17.3) guidance for checkpointing and instructions for configuring it.
Cancel
Vote Up
0
Vote Down
Sign in to reply
Verify Answer
Cancel
Children
No Data