How to improve performance of a PM using integrations?

I have 2 integrations that use REST calls to pull data from an outside system. I have a PM that uses these two integrations (2 nodes). When I run it it takes about 6 seconds to run. If a call the same 2 integrations from an interface, it takes about 3 seconds to run. I have a parent PM where I call this PM containing the integrations in order to pull the data, that way I can take that data and pass it into a form. I just don't like how slow it is. When I kick off the process model and load the form it is noticeable on the front end. 

Is there a way to speed up process models with integrations, or a way to call integrations within an interface without using a saveInto()? Overall I just want to improve the time it takes to run the integrations so the form is faster to load.

  Discussion posts and replies are publicly visible

Parents Reply Children
No Data