I am trying to setup a receive message action in a process model, but while tryi

padmanabhanv over 11 years ago

I am trying to setup a receive message action in a process model, but while trying to select the process model by clicking on "Import Custom Properties" I dont see the main process model which triggers the "Send Message" event from an escalation. It shows "The process model does not contain any events". Any reason as to why this could happen. Both the process models have bene saved and published....

Discussion posts and replies are publicly visible

Parents

0 padmanabhanv over 11 years ago

UPDATE - The event in the parent process is showing up if I add the send message in an "END" node. However the send message event that I have configured as part of an escalation in the same process does not show up. The escalation that sends the Send Message event is at Level 3, could the ordering be an issue there?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 padmanabhanv over 11 years ago

UPDATE - The event in the parent process is showing up if I add the send message in an "END" node. However the send message event that I have configured as part of an escalation in the same process does not show up. The escalation that sends the Send Message event is at Level 3, could the ordering be an issue there?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data