When creating an interface (Appian 7.10), we can now define the input variables

lorib over 8 years ago

When creating an interface (Appian 7.10), we can now define the input variables as their actual CDT instead of using Any Type. The problem I'm seeing is if you update the CDT, the CDT in the input parameter is not updated when you run impact analysis. Is there a way to update the parameter definitions without opening up every interface to do it? Is it better to just stick with Any Type?

Discussion posts and replies are publicly visible

Parents

0 lorib over 8 years ago

Hi simples, after deleting then importing an updated CDT in Data Management, click on the CDT name to open it up. In the upper right next to the Save button there's a menu (the "gear") where you can choose "Check Outdated Dependents". If you have any dependent objects, it will tell you how many and give you an "Update All" button. If something doesn't update, there's an error log that you can look at. I've attached a couple of screen shots. Does that answer your question?
UpdatingCdts.docx
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 lorib over 8 years ago

Hi simples, after deleting then importing an updated CDT in Data Management, click on the CDT name to open it up. In the upper right next to the Save button there's a menu (the "gear") where you can choose "Check Outdated Dependents". If you have any dependent objects, it will tell you how many and give you an "Update All" button. If something doesn't update, there's an error log that you can look at. I've attached a couple of screen shots. Does that answer your question?
UpdatingCdts.docx
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data