I am trying to save data into a CDT variable of type text (multiple). When I lo

Brandon over 10 years ago

I am trying to save data into a CDT variable of type text (multiple). When I look at the CDT in data management, I can see the variable. We can also pass data into this variable using a custom smart service, but I cannot see (or select) this CDT variable in the input or output tables on the activity node within a process model. It's as though all variables within the CDT that are arrays (multiple) are hidden.

Any advice will be greatly appreciated.

thanks
...

Discussion posts and replies are publicly visible

Parents

0 Brandon over 10 years ago

Hi Eduardo. I have tried again numerous times. when TempCoverage is set to "allow Multiple" then I cannot see the required variables, If I change TempCoverage to single (i.e. not allow multiple values), I can select the required variables. The problem is that I have to have TempCovergae set to multiple as there is more than one coverage. so I have multiple coverages with multiple exclusions under each coverage.

It doesn't make sense to me why it would behave this way, so I am most probably going to have to implement a messy work around and create completely new variables outside the CDT.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Brandon over 10 years ago

Hi Eduardo. I have tried again numerous times. when TempCoverage is set to "allow Multiple" then I cannot see the required variables, If I change TempCoverage to single (i.e. not allow multiple values), I can select the required variables. The problem is that I have to have TempCovergae set to multiple as there is more than one coverage. so I have multiple coverages with multiple exclusions under each coverage.

It doesn't make sense to me why it would behave this way, so I am most probably going to have to implement a messy work around and create completely new variables outside the CDT.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data