We have used timer event in process model,which triggers after every 5 min of in

ajinkyab over 12 years ago

We have used timer event in process model,which triggers after every 5 min of interval. we have stored the interval value in constant. but when we change the interval value from back end . the flow wont get triggered according to new interval,because time node is active. is there any way to solve this....

Discussion posts and replies are publicly visible

0 sushilk over 12 years ago

Its just because once node get active it read the value from constant and wait to be condition true. During that duration if you change the value , it is not going to active node. Please use one rule to check the if value is change then re-launch the timer event...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ajinkyab over 12 years ago

hi sushil i tried with this, but still timer run with old interval
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sushilk over 12 years ago

I assume that whenever the value changing in constant your rule ,your process running and it is cancelling the old timer event instance and launch new instance of the same event, If you go data Mangement tab, there is one colum which you need to check, Refersh the value whenever node launch.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ajinkyab over 12 years ago

so i need to keep the timer event in sub process,because timer node don't have exception flow and other tab for cancelling existing instance of timer event node.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 sushilk over 12 years ago

Yes..Whenever it change cancel the old timer procees and launc new..
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ajinkyab over 12 years ago

ya did same working fine
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 siddharthg521 over 12 years ago

You can also put your timer event in a sub process and delete the previous instances of sub process on re-executing. This will make your timer work based on the latest specified value.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel