We have used timer event in process model,which triggers after every 5 min of in

ajinkyab over 12 years ago

We have used timer event in process model,which triggers after every 5 min of interval. we have stored the interval value in constant. but when we change the interval value from back end . the flow wont get triggered according to new interval,because time node is active. is there any way to solve this....

Discussion posts and replies are publicly visible

Parents

0 sushilk over 12 years ago

Its just because once node get active it read the value from constant and wait to be condition true. During that duration if you change the value , it is not going to active node. Please use one rule to check the if value is change then re-launch the timer event...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 sushilk over 12 years ago

Its just because once node get active it read the value from constant and wait to be condition true. During that duration if you change the value , it is not going to active node. Please use one rule to check the if value is change then re-launch the timer event...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data