Can you not have both single columns and multi-column sections in the same form?

mikec over 10 years ago

Can you not have both single columns and multi-column sections in the same form? When designing my form I have a section that is single column and below it another section (this one with header not showing) and it is a 3-column configuration. When I publish in Tempo the entire form is single column and the section I have configured as a multi-column the section header does not display at all and the content is in a single column. I thought that the multi-column formatting only stacked if viewing in a mobile device. Why is the form not adhering to my setup?

Thanks

...

Discussion posts and replies are publicly visible

0 Michael Tan
Appian Employee
over 10 years ago

Hi Mike,
Tempo and iPad forms can only have two columns. Only the legacy forms in the application portal can have more than two. Documentation below:

forum.appian.com/.../Section_Component
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 mikec over 10 years ago

ok. it works now. since you can set it to 3-4 columns and it does not throw and error couldn't figure out why it was not working:-)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel