Hi Everyone , [ I can see by click on interface/constant --> then going to "More"--> we can "Rename" those].
But How do we rename a process model ?Regards,Kasis
Discussion posts and replies are publicly visible
Hi,
This can be done directly within Process Model properties. Simply type a new value into the "Process Model Name" box and save - all done!
Side note, you will likely also want to change the value of the "Process Display Name" field right below that, as it is pre-populated with the process model's original name but then won't change unless you edit it. I typically change it to "=pm!name" as this will make it follow the process model's current name regardless of name changes.
Just as a side-bar here...the "Process Display Name" is what is displayed at run-time in the Process Monitor and, wherever possible, should contain a token to both disambiguate instances of the same model, and correlate with something an end-user would recognise e.g. Claim Number, Case Number, Vehicle Registration Number...so that the Support Team can find instances based upon a shared value between Users and them.
Agreed - this is fairly critical when thinking ahead to production support. It sounds like I was suggesting sidestepping that part, so good point. Often I put this off til later, which is ok as long as you remember to actually follow up on it.