Renaming a process model

Hi,

This can be done directly within Process Model properties. Simply type a new value into the "Process Model Name" box and save - all done! 

Side note, you will likely also want to change the value of the "Process Display Name" field right below that, as it is pre-populated with the process model's original name but then won't change unless you edit it.  I typically change it to "=pm!name" as this will make it follow the process model's current name regardless of name changes.

Just as a side-bar here...the "Process Display Name" is what is displayed at run-time in the Process Monitor and, wherever possible, should contain a token to both disambiguate instances of the same model, and correlate with something an end-user would recognise e.g. Claim Number, Case Number, Vehicle Registration Number...so that the Support Team can find instances based upon a shared value between Users and them. 

Agreed - this is fairly critical when thinking ahead to production support.  It sounds like I was suggesting sidestepping that part, so good point.  Often I put this off til later, which is ok as long as you remember to actually follow up on it.

Agreed - this is fairly critical when thinking ahead to production support.  It sounds like I was suggesting sidestepping that part, so good point.  Often I put this off til later, which is ok as long as you remember to actually follow up on it.